Telephone: +61 (0) 430 195 601

Gyratec G10

Ubersonic » Gyratec G10

Gyratec G10

Gyratec G10


G10 vari-mu stereo compressor – all passive signal path for ultimate analogue audio integrity. Hand made in Denmark from superior quality components.

Share this product


Gyratec G10 vari-mu compressor

*All passive signal path for ultimate analogue audio integrity

*Hand made in Denmark from superb quality components


The G10 is a true tube stereo compressor based on the classic variable-mu principle. This method – controlling the gain by altering quiescent current in differential tube pairs – is much faster than the optical method. The speed is why it was widely used in early limiter devices such as the Fairchild 670 or the Universal Audio 176, but the sonic byproducts of this topology are the main reasons why it is so popular today.

The controls on the G10 are as follows:

The input level pot is positioned right after the input transformers, thus allowing you to control the input level, the “drive” for the compressor.

The Threshold pot controls at what level the compression will set in. Turning counter-clockwise will select a lower start point, resulting in more compression. When turned fully clockwise, the compression is deactivated.

The Ratio pot controls the amount of compression in relation to changes in the input level, that is, for the part of the signal that exceeds the threshold value that is set. Setting Ratio fully counter-clockwise will deactivate compression.

The Attack pot controls the time the compressor takes to react to a rising input level.

The Release pot controls the amount of time it takes from the input signal falling below threshold, to the gain reduction being returned to unity.

The Output level pot controls the signal level to the output driver stage and the output.

The Bypass switch bypasses the unit completely – the hard way. A relay simply takes out the active electronics and shorts the input to the output connectors.

The G10 is floating, transformer balanced in and out. Input impedance > 10K Ohm, output impedance < 1K Ohm.

It is based on a very short true-differential signal path from input to output, using very, very tightly selected PCC189 (7ES8) remote-cutoff dual triodes for the VCA stages, and E88CC (6DJ8) low-noise triodes as cathode followers for the output stage drivers. Both tubes are still fairly easily available throughout the world.

Although semiconductors and op-amps are used in this unit, they’re confined to power supply and side chain functions. At no time will your audio pass through anything but transformers, tubes and passives. So we’re talking REAL tube audio here.

G10 is as standard available as a 230V mains unit – other mains voltages will be made on request (at no extra cost)

We have recently needed to change the face plate of the G10, as the panel meter originally used went obsolete from our manufacturer. The panel meter is the ONLY thing we’ve changed, as the G10 seems to be a very fine design indeed – running unchanged for over eight years now.


There are no reviews yet, would you like to submit yours?